Experiences of a Telecommunication Engineer. My Special thanks go to Sri Lanka Telecom PLC & Etisalat Lanka Pvt Ltd for providing me with a better Training & Working Experience. Mahesh Lanarol Bsc. Eng.(Hons) Department of Electronic & Telecommunication Engineering, University of Moratuwa. NOTE: My posts may include some vendor specific names.
Friday, June 28, 2013
Why we can’t use a normal Firewall instead of a SBC
Normal internet browsing traffic consist of comparably large in packet size and lesser number of packets (i.e. lesser number of headers). A typical firewall will inspect and check the headers. VoIP traffic is different from normal internet browsing traffic. VoIP traffic consists of large number of smaller (smaller in length of the packet) packets which comes in bursts. IP packet headers are more or less the same. If we are using a Firewall in VoIP, it has to process large amount of headers. Hence need more processing in a VoIP (That's why we have to introduce a SBC instead of a normal Firewall). On the other hand in a normal firewall, provided security is low as well. Therefore we use an SBC instead of Firewall. Security level of a SBC is very high.
Monday, June 24, 2013
Next Generation Network (NGN)
In the NGN Architecture, it has two major parts namely WCS (Wireless Call Server) and MGW (Media Gateway). The real intelligent or call processing part is WCS. Different types of
media and
technologies are connected to MGW. All the processing part of connected technologies
and media is handled in WCS. WCS and MGW communicate using a protocol named as
EGCP (Standard protocol =H.248. EGCP is an Alcatel proprietary protocol). WCS
and MGW is connected through an IP/MPLS network. And that IP/MPLS
(Multi-Protocol Label Switching) backbone consists of Routers and Switches.
When we connect two nodes we will always add a redundant path too. Because
especially in telecommunication networks Redundancy is considered as one of the
most important concepts. We never put one, we always put at least two. Because
if one link fails, there is always another link there to carry out the
service. We need to keep the utilization of a link below 50% to make sure that
redundant path can take over the traffic of the failed link.
In a NGN network we
need to provide various services. Such as SIGTRAN, Operation & Maintenance
of the NGN, VoIP services, RNC traffic (IuB, IuPs, etc), etc. These
services/networks should independent from each other. That’s why we use MPLS
network. Using MPLS concepts like VLANs (Virtual Local Area Network) and VPRNs
(Virtual Private Routed Network) we can configure these networks to function
independently. Following Figure: A typical LAN connection will give an idea
about this concept.
Technical
Floor/Engineering Section LAN is connected to the LAN of IT. Technical floor is
also divided into few sub sections. I.e. SWITCH, IN. if a SWITCH engineer wants
to do some operation & maintenance in the telecom network, he can easily do
it by logging into the LAN of SWITCH. Another important thing is how CDRs were
received by the Billing department. As shown in the Figure Billing Server
receives CDRs through IT network.
Consider a company where majority of IDD calls are VoIP. For VoIP we use SIP (Session Initiation Protocol). Now companies are using a device called SBC (Session Border Controller) which is regularly deployed in VoIP networks all over the world. SBC will protect the network and devices from malicious attacks and at the same time will allow different parts of the network to communicate through the use of variety of techniques such as NAT (Network Address Translation), SIP, IPV4/6, etc.
Following figure will give you a clear idea on how the previous system was there and how it is replaced now using a SBC.
Subscribe to:
Comments (Atom)



